

Nymph
Copper John
John Barr’s wire-bodied nymph — the anchor fly that gets the rest of your rig to the bottom.
Available at Amazon and Walmart
- Hook size
- 20
- Best water
- Freestone River, Spring Creek, Tailwater
- Colour
- Natural
- Pack
- 12 flies
How to fish it
Fishing notes
Point fly, 18 inches below a smaller pupa or emerger, under an indicator set at roughly twice the water depth. Dead drift through the deepest part of the run. It also works as the dropper under a Chubby Chernobyl.
Set the indicator at roughly twice the depth of the water and then adjust by feel: if you are never touching bottom you are fishing above the fish, and if you are hanging up every drift you are a foot too deep. On a good drift you should tick the substrate two or three times through a run. That contact is worth more than any change of pattern.
If nothing takes it through water you trust, change the fly above it rather than the Copper John. The anchor is doing a job that has little to do with what the trout eats — it is getting the rig down and holding it there — so the honest experiment is to swap the upper dropper between a midge, a mayfly emerger and a bright attractor until one of them answers.
About this fly
John Barr’s wire-bodied nymph — the anchor fly that gets the rest of your rig to the bottom.
The Copper John does two jobs at once. It is a credible mayfly nymph, and because the body is wound copper wire over a bead, it is heavy enough to act as the anchor on a two-fly rig without adding split shot. That combination is why it has been in more boxes than almost any nymph tied in the last thirty years.
Size 20 is the tailwater size — small enough for pressured fish, still heavy for its size because of the wire. Fish it as the point fly and hang something smaller and softer above it.
The weight is the whole argument for it. A size 20 nymph tied on thread weighs almost nothing and rides wherever the current takes it; the same fly with a wire body and a bead cuts down through the top of the column and holds a line. That is why it works as an anchor at a size most anglers would not think of anchoring with, and why it fishes water that a heavier, larger fly would spook fish out of.
Key features
- Wound copper wire body sinks fast — anchors a nymph rig without split shot
- Reads as a mayfly nymph while the flash gets it noticed in fast water
- Size 20 for pressured tailwater fish that refuse anything larger
- Designed by John Barr; one of the most proven nymphs in modern fly fishing
- Fish it on point with a midge or emerger on the upper dropper
Further reading
- The Dry-Dropper Rig: One Setup That Covers the Whole River 5 min read
- The Winter Midge Game on a Tailwater 5 min read
- How to fish a Copper John on tailwater 2 min read
More patterns
Fish these alongside it






